Sirius Satellite Radio Installation for the ’00-‘06 E46 3 Series
Coupe and Sedan
Tools Required:
• Panel Removal Tool
• 8mm socket wrench (CD Changer Removal)
CRITICAL Installation Notes:
This is a VERY simple installation, as we are simply plugging in the factory CD changer wires into
the Sirius module, routing the included cable from the Sirius back to the CD changer (when
equipped), and plugging the antenna into the Sirius Module. That’s it.
Don’t forget to write down the Sirius ID number, located on the Sirius module. You’ll need it to have Sirius
activate the module.
Do NOT plug the 3 pin connector into the Sirius Module until all other connections have been made. This is
imperative.
The Process:
We’ll begin by disassembling the trunk first..
1. Begin by removing all items from the trunk of the vehicle. Make sure that all tail lights are
in working order. If not, now is a good time to replace them. Also remove the carpet that
covers the floor of the trunk, as it will reveal a couple of fasteners that will need removing.
2. Start by removing the taillight covers. Push inward on the clip, and the light will release
itself. Now depress the wiring clip attached to the light bulb housing to release the
housing, and move the housing safely away from your working space (Photo on next
page).
1 of 7
Any reproduction, distribution, modification, or dissemination of these instructions without written permission from Bavarian Soundwerks is
expressly forbidden and a violation of international copyright law. Any violation will result in persecution to the full extent available under
the law!
© 2006 Bavarian Soundwerks, LLC.
2195 Defoor Hills Rd., Suite D, Atlanta, GA 30318
P: 404.963.8857 |
File Type: PDF Download here